You are not logged in.

#1 01-28-2015 12:25:56

StudioMenno
Nouveau membre
Registered: 01-28-2015
Posts: 3

Scan a photo with a shape

I do not know if it is possible, but this is what I would like to do.
I want to use the key hole shape and make it small showing only a part of the photo. Then I want to move the shape over the photo so that other parts of the photo can be seen through the key hole.
In the end I want to enlarge the key hole so that in the end all of the photo can be seen.

Can this be done in ffdiaporama?

What I tried so far is making a small key hole on the photo, but after finishing it the key hole is shown full screen and the photo is enlarged. But I want the photo to keep the same size and let the key hole be small and move over the photo.

Offline

#2 01-28-2015 13:05:04

StudioMenno
Nouveau membre
Registered: 01-28-2015
Posts: 3

Re: Scan a photo with a shape

Now I managed to resize the key hole with the photo an position it on approximately the right position using the same image as a temporary background. Then I copied the frame and repositioned the key hole. On the last frame I enlarged the key hole so that the whole picture is visible. But there are still some differences in size and position and the animation is wiggling a bit.
Is there a better way to do this?

Offline

#3 01-28-2015 17:56:45

Sestay
Modérateur
Registered: 09-19-2011
Posts: 463
Website

Re: Scan a photo with a shape

hi!
Something like this project https://www.dropbox.com/s/rkdkkzowo960y … e.ffd?dl=0
If you want a making off tell me.
I quickly  made a how to do you can have it https://www.dropbox.com/s/u8y4jcrfse7tl … e.pdf?dl=0

Last edited by Sestay (01-29-2015 10:29:40)

Offline

#4 02-04-2015 21:49:48

StudioMenno
Nouveau membre
Registered: 01-28-2015
Posts: 3

Re: Scan a photo with a shape

It is something like that, but I see your photo is also moving a bit. I want to get it steady.

Offline

Board footer